Search
You are here: Home » Sawing technology » Edging and resawing technology

Edging and resawing technology

[two_third_text]
Following the opening of the stemwood with the main machines, resawing and edging are further significant steps along the value chain from the log to the fully shaped, sharp-edged board.

 

With our machine technology, you will achieve the maximum yield from pre-cut cants during these processing steps.

 

We achieve this by:

 

 

Our scope of supply includes:

 

 

We also provide the interface for transferring the timber data as length, width, thickness and quality and position, thereby enabling a separation for sorting. Any additional classification or measuring is not required. Measuring errors are excluded.
[/two_third_text]

[one_third_image_last]


[/one_third_image_last]

 

Machine ASM 200 ASM 300 KSM 200 NSM 250
Cutting height 18 – 130 mm 18 – 60 mm 18 – 200 mm 40 – 250 mm
Width unedged 750 mm 650 mm 800 mm 800 mm
Fed-in lengths 1 – 6 m 1,5 – 6 m (depending on requirements – also timber lengths for the construction industry) from 2,5 m (depending on requirements)
Variable products 2 – 3 products, variable 5 products, variable
Feeding system Chain bed combined with pressure rollers above
  • Chain pressure bar above
  • Alternatively with aligning table
  • With bottom chain bed
  • Wheel centering unit
  • Feed unit with side guide rollers
Feeding speed up to 240 m / min. up to 300 m / min. up to 180 m / min. up to 60 m / min.
Output up to 20 cycles / min. up to 30 cycles / min. up to 15 cycles / min.
Measuring Laser measuring Laser measuring combined with camera system Camera system
Edging widths 2-board version
24 – 400 mm
18 – 400 mm
3-board version
48 – 400 mm