Search
You are here: Home » Sawing technology » Edging and resawing technology » Edging technology

Edging technology

Due to their extremely robust design, our edgers deliver continuously and reliably optimum cutting results with an output of up to 30 boards/min.

 

The measuring of the timber is made in transversal passage by laser sensors from above, optionally from below. The measuring grid is 500 mm, optionally 250 mm. In combination with our „LM-Optim“ optimization software, you will get the maximum possible yield.

 

The wane-based alignment allows a highly flexible and value-optimized cutting of the products by 3 separately adjustable saws and at cutting heights from 18 to 130 mm.

 

It is also possible to freely define slats of different lengths on the left or right side of a board. Additionally, it can be set starting from which length side slats shall be produced.

 

4 adjustable sawing axes allow the variable sawing of up to 3 (main) products. By appropriately equipping the fixed chucks it is possible to additionally produce side products such as slats.

 

The fixed chucks can be fitted as required; the useful length is limited to 235 mm, the possible opening width of the splitting wedge ranges from 48 to 800 mm.

 

Through the variable fitting of the fixed chucks it is possible to produce both slats and framing timber with different dimensions at the same time.

 

Our scope of supply includes the complete materials handling technology required for the continuous feeding of goods and the further transportation of the timber.

 

The saw feeder can be controlled via a joystick. Our optimized operating concept for the control of the feed system to the saw and the saw itself from within the operator station using a joystick greatly relieves your staff.